First of all, we should be clear that the direction of the bearing capacity will change when the shelves are placed with the rolling goods, so the multi-storey workshop is not suitable to put the heavy shelves? The following powerful Xiaobian will give you to know together
A, in a heavy shelf rolling goods, because the shelf bearing capacity in addition to downward, expand to both sides of the shelf, so such goods can not be simply with beam, the best solution is to design the shelves on the well type iron net gear, of course, due to the different actual bearing capacity, to appropriately increase the corresponding specifications of gear material and the number of horizontal support beam.
Two, after an in-depth understanding of the actual situation of the customer, the shelf gear is best to use heavy shelf beam special profile: welding beam, then in accordance with the way of vertical two horizontal three arrangement, using the way of welding to weld these profiles, in order to safer put rolling goods, usually in some must protect the position to protect the shelf column. The foot protection is generally at the first end of the middle shelf, which can prevent the forklift when operation, causing damage to the shelf or endangering the safety of the shelf.
III. The structure of heavy storage shelf fully applies to the requirements of rolling goods, reasonably transforming the force of different directions into the force of the same side, so that the overall force of the shelf is more coordinated and the overall stability of the shelf is higher.

IV. First, we should look at the fixed formula for heavy storage shelves: ground plane is greater than 25; 20; cement ground is 2000-3000kg/m2 generally; shelf load is heavy: ground plane is greater than 25; ground level is greater than or equal to 30;
 Generally, heavy-duty storage shelves reach about 2,500 kg per layer, and a single set of weight shelves can generally reach 12,000 kg. The steel plate can be directly welded directly on the column underfoot, and the shelf factory makes holes directly in the column floor, and then fixed directly to the ground with two expansion screws. Therefore, the heavy shelf requires a high layer load on the ground, so it does not apply to the multi-storey workshop, unless the load of the heavy shelf is not very large.

The medium shelves are generally carried around 400kg each floor, the light shelf weight is lighter, can be used in almost any workshop, and is not high for the warehouse floor. However, the load-bearing of the heavy storage shelves is relatively heavy, and the pressure on the ground will be very great. The general high-rise workshop is relatively difficult to meet its requirements, so the multi-storey workshop is not sure to be used. Normally, all the shelf factories will take into account the above two points into consideration when conducting the heavy shelf project design, as the procurement personnel in the heavy shelf procurement, also need to remind the shelf factory home about the plant and the ground problems.

Dingli Guangzhou shelving Factory has been holding the principle of safety first for more than 10 years to serve the public. To meet customer needs, we will never put customers in danger. For more cases of heavy-duty storage shelves, please click on: www.gzdlcc168.cn. Or call: 020-82002201 / 18102581498